Horn Wire Feed Clips (4)

In Stock | FREE Shipping on orders over $50
Calculated at Checkout

Description: Horn Wire Feed Clips (4)
Model: Mustang, Shelby, Cougar, Ford, Mercury
Model Options: 

Ford Hardware #
Factory: San Jose, Dearborn, Metuchen
Material: Black nylon plastic
Quantity: 4
Opening Measurement: 1/4"  

Accuracy Rating: 9
Best Repro Available: YES

Jack's Comments:

This is a set of the four clips typically used to hold the horn wire lead to the outer radiator support. This is the most common version especially for 1969 production but some factories use this clip in combination with the larger version. See pictures below.

BOSS 429 and oil cooler equipped car notes:
Sometimes these clips didn't get installed on the drivers side. The horn wire lead on the drivers side would be secured in one of two ways: 1) The horn lead off the main harness would be laid down parallel to the main harness it feeds from then cloth taped close to the terminal to hold it in place. 2) These plastic clips are used to hold it to the radiator support like a non-oiler cooler car but the terminal end would be turned down and tucked under itself. 

Larger Clips:
We have also seen some survivors that only had the larger version of this clip that were black or opaque white in color. We have documented several Metuchen built Mustangs with only the larger opaque white clip (not available in reproduction).  Do your research before purchasing.


Made in USA

No one has reviewed this product! Write a Review

Related products