Description: Leaf Spring Clamp Set | ROUND HOLE 
Year: 1969-70
Model: Shelby GT350, Shelby GT500
Dimensions: 2.5" wide
Finish: Bare cold rolled steel
Quantity: 1 set (4 clamps)

Accuracy Rating: 8
Best Repro Available: YES

Jack's Comments:

This a set of four special round hole leaf spring clamps found on 1969 and 1970 Shelby. Made in USA in small production runs.

Concours notes:
1) They are bare steel just like the originals.
2) Some suspect the lower production cars like the Shelby were put together by a specialty division of the leaf spring facility that used this round hole clamp.
3) These clamps were laser cut vs punch die so the sides have soft fine horizontal lines vs a torn look from being punched out of a die. This is why we gave them an eight rating on accuracy otherwise we would have given them a ten.

Install Notes:
1) Take pictures of both springs before you take them apart so you have an idea of how to put them back together.
2) Once the tabs are bent to install they will most likely will not be able to be bent back without cracking.
3) C clamps are a good way to hold the clamp in place before bending the tab over with a sledge hammer. This will insure you will get them on tight as possible. Here is a link to a Concours Mustang Forum post discussing the install.

Applications:
1969 Shelby GT350
1969 Shelby GT500
1970 Shelby GT350
1970 Shelby GT500

*Free standard shipping on orders over $50 USD to the lower 48 states